The Arduino WiFi DiamondBack is a Uno compatible clone that has built-in wireless connectivity, eliminating the need for a bulky shield. So it's like "Uno+WiFi-shield-in-one"!

Get Your WiFi ON! With the Arduino WiFi DiamondBack

Arduino WiFI DiamondBack

The Arduino WiFi DiamondBack is a Uno clone that has built-in 802.11b wireless connectivity. It uses surface mount components which free up space on the board allowing room for the wireless module.

It is fully compatible with its older counterpart, the Asynclab BlackWidow. It is also compatible with the Arduino IDE, just select "Uno" as the board.

Features:

  • Same form factor as existing Uno, Duemilanove and Diecimila boards.
  • 14 digital I/O pins and 6 analog input pins.
  • Atmel ATMega328P microprocessor.
  • 32KB flash RAM (2KB used for bootloader).
  • 2KB SRAM and 1KB EEPROM.
  • Uses the smaller USB mini-B connector.
  • Power is auto-switchable between USB and external DC.
  • 2-pin JST connector allows for other external power options (for instance Lithium-ion battery pack).
  • 802.11b wireless connectivity (1 and 2 Mbps).
  • On-board antenna.
  • Switchable interrupt between INT0 and digital pin 8.
  • Supports infrastructure and adhoc network modes.
  • Support for WEP, WPA, and WPA2 security.
  • LED (attached to digital pin 9) indicates a successful wireless connection.

Get your Arduino WiFi DiamondBack here.